ELECTRONICS

VACUUM GRADE SILICONE RUBBER BLADDERS & MEMBRANES FOR AEROSPACE

Hi-Performance Products offers a wide variety of FDA compliant mesh & fabric release material that was specially formulated for use in the Dehydrator Processing Industry, to eliminate products from sticking to the dehydrator trays.

P/N: HP50VB Up to 72″ Splice Free 73″ to 100″ with “Invisible Splice”

This particular specially compounded formulation is produced specifically for the aerospace/ aircraft manufacturing facilities throughout the world. It meets all the stringent requirements of the Federal Procurement Specification known as ZZR-765E class 3B Grade 50. This 50 durometer high strength silicone sheet is produced with a fine textured fabric finish on both sides. This finish is highly sought after because of its ability to very quickly wick out all air during Vacuum Bagging procedures. It has amazing reusability, durability and it also will slide or float over-layed up parts with great ease.

This product has extraordinary “Drawdown” strength and resiliency. this makes it’s performance remarkable when exposed to the high pressures and elevated temperatures it can encounter in autoclaves during cure cycles of composite structures. In the cured or uncured form it allows the fabricator unparalleled versatility in designing intricate shapes and contours. Another characteristic is it’s excellent resistance to weather, ozone, hot water, low pressure steam, alcohols, diethelyene glycol and average resistance to petroleum base oils. However, it is not recommended for service in aromatic solvents, fuels, chlorinated solvents and acids. When speaking of service temperature ranges one can consistently expect -100F to +450F. This high strength silicone sheet is available in both the uncured and cured form in a wide variety of thicknesses. Also, the widths of these sheets are available up to 72″ wide without a splice!. The physical properties below are for the most popular high strength silicone sheet.

TYPICAL PHYSICAL PROPERTIES:

This product has extraordinary “Drawdown” strength and resiliency. this makes it’s performance remarkable when exposed to the high pressures and elevated temperatures it can encounter in autoclaves during cure cycles of composite structures. In the cured or uncured form it allows the fabricator unparalleled versatility in designing intricate shapes and contours. Another characteristic is it’s excellent resistance to weather, ozone, hot water, low pressure steam, alcohols, diethelyene glycol and average resistance to petroleum base oils. However, it is not recommended for service in aromatic solvents, fuels, chlorinated solvents and acids. When speaking of service temperature ranges one can consistently expect -100F to +450F. This high strength silicone sheet is available in both the uncured and cured form in a wide variety of thicknesses. Also, the widths of these sheets are available up to 72″ wide without a splice!. The physical properties below are for the most popular high strength silicone sheet.

Shore (A) Hardness
Tensile Strength
Elongation at Break
Modulus at 300% Elongation
Tear Strength
Compression Set (22hrs @ 350F
Available Thickness
Surface: 		50 +/-5*
1300 psi
800 %
400 psi
240 psi
19%
.062" to .125"
Smooth or Fine Fabric Finish

* Available Hardness: 40A, 45A, 50A, 55A and 60A

The above values are typical properties and are provided for information only. They should not be used to set specification requirements. It is up to the end user to determine whether the material is suitable for the intended application. Sellers & manufacturers only obligation shall be to replace such quantity of the product found to be defective.